If I knew that a rework station properly maintained was going be available I would stop hauling mine to the workshop. I normally only need to replace a couple parts each workshop. Most of the time is figuring out which part. I don't make every workshop. On Sat, Oct 22, 2022 at 11:34:06AM -0400, Martin Flynn via vcf-midatlantic wrote:
CDL has removed the dead Liebert CRAC system from the Makerspace, freeing up room to potentially set up a dedicated board repair / rework station on the wall common to the classroom.
This is what we have to start with:
* Hakko C1392B Positioning fixture * Hakko C1390C Omnivise (three) * Hakko FM205 Shop air de-soldering station
To validate the concept, how much use would VCF make of this for restoration and workshops?
Martin