All I did so far is apply power. I see the filament glowing. I don't see a raster, so I assume it needs a signal or maybe also pots on the contrast and brightness. Not geared up to provide those connections yet, my workbench is a mess! On Wed, Jul 31, 2024 at 10:12 AM Dave McGuire via vcf-midatlantic < vcf-midatlantic@lists.vcfed.org> wrote:
Have you fired it up yet? I'm curious to know if they're actually PAL (by default) as I had read some time ago. I've still not tried any of the ones that I picked up from AliExpress last year, but I will soon. Thanks again for sliding me a set of cables while you were here!
-Dave
On 7/30/24 08:57, Chris Fala via vcf-midatlantic wrote:
Thanks all for the responses to my question. Based on your suggestions, I tried these (below) which worked!
https://www.amazon.com/dp/B08L6QFXRT
On Thu, Jul 18, 2024 at 4:18 PM Kyle Owen via vcf-midatlantic < vcf-midatlantic@lists.vcfed.org> wrote:
Hard to say without measuring the pitch of the connectors, but they certainly look like JST XH-series connectors, which have a 2.5mm pitch.
https://www.adafruit.com/product/4876
On Thu, Jul 18, 2024, 15:00 Chris Fala via vcf-midatlantic < vcf-midatlantic@lists.vcfed.org> wrote:
Can anyone tell me what type of connectors (4 pin and 6 pin) are on this item, and if they are readily available (preferably with wires already terminated)??
https://www.amazon.com/Monitor-Vintage-Screen-Electronic-Picture/dp/B09DXST3...
Thanks in advance!
-- Dave McGuire, AK4HZ New Kensington, PA