12 Feb
2016
12 Feb
'16
10:59 p.m.
For those top pieces, I'd get smoked plexi, cut it to size, and bend it using a hot wire bending jig. Finally, paint the lower bit blue. Bigbluesaw.com may be able to make the smoked plexi piece with vent slots, then we do the bending and painting. Bill Dudley On 02/12/2016 10:44 PM, Evan Koblentz via vcf-midatlantic wrote:
For those of us who haven't seen a PDP-8 in decades, what does the side panel look like?
Plastic: http://www.ganssle.com/tem/tem231-pdp8a.JPG
Each panel has three sides. It hangs from the top where there are vents in the plastic. The dark middle section is translucent.