Hey all, some of you may have grabbed one (or more) of the paper tape readers readily available on ebay that likely have come from CNC machines. I was just wondering if anyone has actually made these work? It seems many of these have a standard pinout/spec depending on what CNC controller they were connected to.I had one I bought some time ago, a Sanyo-Denki 2401 model, and it seems this was often used on a Yasnac 2000G controller, and has a 40pin ribbon cable connection, whereas others use a 50pin ribbon cable (on Fanuc controllers). Just wondering if anyone has ever gotten one of these running, or perhaps knows anything about them? I spent a couple hours with mine yesterday and determined most of the pinout, but I don't know what voltages the power input should be. I have a bunch of notes and the data side is relatively simple, its the control side I'm struggling to sort out. Jeff aka Bags