[vcf-midatlantic] PiDP8

[william degnan]

It's not working like I had hoped, but I think it's the connector adapter I
am using.  I don't get clean operation when the cable is attached, too much
electric noise I am guessing.  I need to order a short cable with a clean
connector without a bare adapter.

[---------------]     Light Panel
 ||||||||||||||||||  <---bare adapter / problem here?)
[---------------]
        ||
        ||
        ||
        ||
        ||
        ||
[--------------]
 ||||||||||||||||||      R Pi


On Fri, Dec 30, 2016 at 3:53 PM, Douglas Crawford via vcf-midatlantic <
vcf-midatlantic at lists.vintagecomputerfederation.org> wrote:

> Well that's a clever idea, I didn't think of stringing the whole I/O cable
> out the back.
> That's the most flexible thing to do especially if you plan to make the
> box fairly sealed.
> With my Zero, I still have to go in there to get the SD card.  Bravo.
>
> On 12/29/2016 11:52 PM, william degnan via vcf-midatlantic wrote:
>
> My plan to finish is to house the RPi  externally perhaps in a little box
> on the back so I can eventually switch in a Next Thing Co CHIP
>
>
>