[vcf-midatlantic] Chip Salvage
jsalzman at gmail.com
jsalzman at gmail.com
Sat Apr 17 03:06:21 UTC 2021
I did it with a cheap hot air gun from Harbor Freight Tools. Just move the
hot end of the heat gun around the chip(s) you want to release, then bang
the board against an edge in a way that the chip would fly out of its spot
while all the solder on its pins is melted.
Don't worry about burning the PC board too much. You're going to throw it
away anyway. Just do it all outside so you don't have to tolerate much of
the off gassing the board does under direct heat like that.
Clean the solder off the chips later.
On Fri, Apr 16, 2021 at 8:29 PM Duane Craps via vcf-midatlantic <
vcf-midatlantic at lists.vcfed.org> wrote:
> Group,
>
> I remember reading a article many years ago, I think it was in BYTE,
> about salvaging IC's from discarded Printed Circuit Boards by using a
> chip puller and a torch on the back. Has anyone actually done this? I
> guess now you could try with a hot air gun?
>
> --
> DuaneCraps
> sdɐɹɔ ǝuɐnp
>
>
More information about the vcf-midatlantic
mailing list