[vcf-midatlantic] OT: Help at InfoAge 7/31 for drilling holes, cutting blocking, mounting equipment

Martin Flynn maflynn at theflynn.org
Sun Jul 25 20:44:13 UTC 2021


Bring your implements of destruction!!

Likely better than our hammer drill.

Got a 1/4" bit for it??

Martin


On 7/25/2021 4:31 PM, Jonathan Chapman via vcf-midatlantic wrote:
> Not sure what your equipment is like, but I've got a Hilti SDS rotary hammer if you guys have only a standard hammer drill. That concrete is going to be old and very tough!
>
> Thanks,
> Jonathan
>
> ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
>
> On Sunday, July 25th, 2021 at 16:09, Jeffrey Brace via vcf-midatlantic <vcf-midatlantic at lists.vcfed.org> wrote:
>
>> Martin will be at InfoAge on July 31 from 9AM to 5PM and needs help with
>>
>> the following:
>>
>> -   Set the cable anchors in the hotel basement for the fiber optic cables
>>
>>      (about a dozen 1/4" holes in the concrete beam between the front wall of
>>
>>      the hotel and the column by the rack)
>> -   Open up the holes for the equipment rack in the hotel basement floor.
>>
>>      (four 1/2" holes with a hammer drill)
>> -   Mount the network equipment rack in the furnace room at the read of
>>
>>      9032A.
>> -   Assemble and rack the second UPS in 9059, and move red power cables to
>>
>>      it.
>> -   Drill the hole from the media recover office on the second floor of
>>
>>      the hotel into the attic. (one 1/2" hole with a hammer drill)
>> -   Cut the blocking for the underside of the engineers desk in 9059 with
>>
>>      the little table saw.
>>
>>      Anyone willing to help anywhere in that time frame?
>>
>>      =========================================
>>
>>      Jeff Brace
>>
>>      Vice President & Board Member
>>
>>      Vintage Computer Festival East Show-runner
>>
>>      Vintage Computer Federation is a 501c3 charity
>>
>>      http://www.vcfed.org/
>>
>>      jeffrey at vcfed.org


More information about the vcf-midatlantic mailing list