[vcf-midatlantic] OT: Help at InfoAge 7/31 for drilling holes, cutting blocking, mounting equipment

Kenneth Gober kgober at gmail.com
Mon Jul 26 16:40:21 UTC 2021


I can come down as well.  I'll bring my Bosch SDS-Plus hammer drill but I
only have 1/2" and 3/4" bits for it.  The 3/4" bit says it's for concrete
with rebar.

-ken

On Sun, Jul 25, 2021 at 4:44 PM Martin Flynn via vcf-midatlantic <
vcf-midatlantic at lists.vcfed.org> wrote:

> Bring your implements of destruction!!
>
> Likely better than our hammer drill.
>
> Got a 1/4" bit for it??
>
> Martin
>
>
> On 7/25/2021 4:31 PM, Jonathan Chapman via vcf-midatlantic wrote:
> > Not sure what your equipment is like, but I've got a Hilti SDS rotary
> hammer if you guys have only a standard hammer drill. That concrete is
> going to be old and very tough!
> >
> > Thanks,
> > Jonathan
> >
> > ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
> >
> > On Sunday, July 25th, 2021 at 16:09, Jeffrey Brace via vcf-midatlantic <
> vcf-midatlantic at lists.vcfed.org> wrote:
> >
> >> Martin will be at InfoAge on July 31 from 9AM to 5PM and needs help with
> >>
> >> the following:
> >>
> >> -   Set the cable anchors in the hotel basement for the fiber optic
> cables
> >>
> >>      (about a dozen 1/4" holes in the concrete beam between the front
> wall of
> >>
> >>      the hotel and the column by the rack)
> >> -   Open up the holes for the equipment rack in the hotel basement
> floor.
> >>
> >>      (four 1/2" holes with a hammer drill)
> >> -   Mount the network equipment rack in the furnace room at the read of
> >>
> >>      9032A.
> >> -   Assemble and rack the second UPS in 9059, and move red power cables
> to
> >>
> >>      it.
> >> -   Drill the hole from the media recover office on the second floor of
> >>
> >>      the hotel into the attic. (one 1/2" hole with a hammer drill)
> >> -   Cut the blocking for the underside of the engineers desk in 9059
> with
> >>
> >>      the little table saw.
> >>
> >>      Anyone willing to help anywhere in that time frame?
> >>
> >>      =========================================
> >>
> >>      Jeff Brace
> >>
> >>      Vice President & Board Member
> >>
> >>      Vintage Computer Festival East Show-runner
> >>
> >>      Vintage Computer Federation is a 501c3 charity
> >>
> >>      http://www.vcfed.org/
> >>
> >>      jeffrey at vcfed.org
>


More information about the vcf-midatlantic mailing list