[vcf-midatlantic] WTB: Teletype Model 33 ASR Chad Bucket

[Jonathan Chapman]

Looks like I'm all set, worked out a trade!

Thanks,
Jonathan




------- Original Message -------
On Thursday, June 23rd, 2022 at 13:43, <dave.g4ugm at gmail.com> wrote:


>
>
> > ________________________________
>
> > From: vcf-midatlantic vcf-midatlantic-bounces at lists.vcfed.org on behalf
>
> of
>
> > Jonathan Chapman via vcf-midatlantic vcf-midatlantic at lists.vcfed.org
> > Sent: Thursday, June 23, 2022 8:08 AM
> > To: Alexander Jacocks jjacocks at gmail.com
> > Cc: Jonathan Chapman lists at glitchwrks.com; vcf-midatlantic <vcf-
> > midatlantic at lists.vcfed.org>
> > Subject: Re: [vcf-midatlantic] WTB: Teletype Model 33 ASR Chad Bucket
> >
> > Not too interested in a 3D printed option, I can cob a solution easier
>
> than that :P
>
> What is "easier" than a 3D printed option when a design exists and some one
> else prints it?
> I looked at the design in question. It should just fit where the original
> goes. Two others have printed it.
> It was slow but that's usual for 3d printing...
>
> > I'd like one actual Teletype chad bucket just because the rest of the
>
> machine is
>
> > pretty complete/original.
>
>
> Of course that would be ideal..
>
> > Thanks,
> > Jonathan
>
>
>
> Dave
> G4UGM
>
> > ------- Original Message -------
> > On Wednesday, June 22nd, 2022 at 21:10, Alexander Jacocks
> > jjacocks at gmail.com wrote:
> >
> > > Jonathan,
> > >
> > > Would something like this be workable? It seems like a 3D printed direct
> > > replacement for an ASR 33 chad bucket:
> > >
> > > https://www.thingiverse.com/thing:3353088
> > >
> > > I'd be happy to print you one, if so.
> > >
> > > - Alex
> > >
> > > > On Jun 22, 2022, at 7:12 PM, Jonathan Chapman via vcf-midatlantic <vcf-
> > > > midatlantic at lists.vcfed.org> wrote:
> > > >
> > > > All,
> > > >
> > > > Looking for a chad bucket for my Model 33 ASR. I finally have it set up
>
> where
>
> > it can be used regularly again!
> >
> > > > Thanks,
> > > > Jonathan